How To Setup Custom Zones

How To Setup Custom Zones

Zones allow you to create a virtual geographic boundary which will alert you if the device enters or exits a specific zone. 

To setup a custom zone for your GPS device, please follow the step by step instructions provided below. 

Step 1: Log into your GPS account at www.amcrestgpstracker.com using the current username and password associated with your account. Click Login

4refd.PNG

Step 2: Click on the Zones tab located in the main menu of the GPS portal. 

vcerwq.PNG

Step 3: Click on the “Got It!” button to proceed. 

fwtr.png

Step 4: Click on Add New Zone to begin adding a new zone. 

There are 2 different types of zones that can be created:

Keep-In Zone – These zones can trigger an alarm if the tracker is detected outside its boundaries.

No-Go Zone – These zones can trigger an alarm if the tracker is detected within its boundaries.

qyt5.png

Enter in a name for your zone in the Enter Zone Name field, then select which type you would like to associate with your custom zone. After you have entered this information click on Create Zone to continue. 

 

oto.png

Your zone has been created successfully. Click Ok to continue. 

Step 5: Next, you will be prompted to create an alarm for the created zone. If you would like to set an alarm (notification) for this specific zone select, “Yes” if you wish to proceed without an alarm, select “No”.

ykyr.png

Note: For more information on how to configure alerts click here.

Step 6:  Plot the custom area of your zone. To plot the points on your map, you will need to click on the indicated area and then drag each point to plot your graph. The endpoint will end at the original start point of the custom zone.

g543wy.png

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.