How To Physically Install And Setup Your Amcrest License Plater Reader Camera (IP4M-1072EW-AI)

Before installing your camera, please make sure the installation surface can support at least 3x the weight of the camera. It is highly recommended to put a MicroSD card into the camera before physical installation. The camera can be installed in the center or side of lanes, with different recommended distances for mounting.

Mounting height and the best distance to capture:

For more information about the installation of your new ANPR camera, please refer to the information provided in this section.

Ceiling/Wall Mounting
A drill with an 8mm diameter head as well as a wrench will be required to complete this process. The same concept can be applied as well if mounting to side wall or other similar mounting surface.

1. Place the installation sticker onto the mounting surface and drill the 3 holes provided on the sticker	2. Use the provided torx wrench to open the junction box. Remove the junction box from the camera and place the foam pad on the bottom of the junction box.
3. Place the wall anchors into the holes provided on the surface. Align the holes of the junction box to the wall anchors and attach the bottom of the junction box to the mounting surface.	4. Feed the network cable, power cord, etc. into the corrugated pipe. Attach the waterproof connector and pipe to the side of the junction box and run the wiring inside and connect the wiring. Note: If POE+ is being applied, do not attach the power adapter connection.
5. Secure the camera back onto the junction box using the provided torx wrench. Adjust the angle of the camera using the lock/unlock screw provided on the bracket.	6. Ensure the camera is in the most adequate position and all wiring is secure and properly weatherproofed.

Pole Mounting
If mounting to a pole, please make sure the pole and installation area can support 3 times the weight of the camera. Pole mount will be sold separately.

1. Attach the pole mounting bracket to the installation surface and tighten the bolts to secure the bracket to the pole.	2. Open the junction box, run the wiring through the bracket, align the holes of the junction box to the mount and attach the box to the pole mount bracket.
3. Connect the wiring to the camera and secure it to the junction box using the provided torx wrench. Adjust the angle of the camera if needed. Note: If POE+ is being applied, do not attach the power adapter connection.	4. Ensure the camera is in the most adequate position and all wiring is secure and properly weatherproofed.