How to Setup Wi-Fi (ASH42)

How to Setup Wi-Fi (ASH42)

The Wi-Fi setup method is the preferred setup method for your device. However, if is not an option the camera can also be setup using a direct connection with an Ethernet cable. Please note, the camera can only be setup on either a Wi-Fi only connection or an Ethernet only connection. For more information on how to setup your camera using an Ethernet connection, click here.

For more information on how to setup your camera using Wi-Fi please refer to the information provided below. 

Step 1: Log in and click on “Add Device”.

mceclip0.png

Step 2: Scan the QR Code on your device or manually enter the serial number for the device by tapping “Manually enter S/N”. The serial number can be found on the serial tag located on the camera.

mceclip1.png

Step 3: To setup a WiFi connection (recommended) tap “WiFi Setup” to continue.

mceclip2.png

Note: WiFi setup will only allow your camera to connect via a 2.4GHz Wi-Fi connection. 

Step 4: Ensure the green LED on the front of your camera is blinking, this indicates the camera is ready to be connected.  Tap “Next” to continue.

mceclip3.png

Step 5: Type in a password you would like to use and confirm it. Please use a combination of letters, numbers, and symbols between 8- 32 characters long when setting up a password. Tap “OK” to continue.

mceclip4.png

Step 6: Select your Wi-Fi network from the Wi-Fi network list. Enter the password for your home Wi-Fi network. If you would like to save this password to the app, tap on “Save Password”.

mceclip5.png

Step 7: The LED on the front of camera will turn solid green when connected. If it does not turn solid, tap on “Start Over” to try again. Tap “Next” to continue.

mceclip6.png

Step 8: Rename your device. A few examples are provided such as, Front Door, Storage Room, Office, etc. Tap “Save” to continue.

mceclip0.png

Step 9: Set “Time Zone” to your current time zone and set “DST” (Daylight Savings Time) settings if applicable. Tap “Next” to continue.

mceclip1.png

Step 10: Tap Start Live View to view the live feed.

mceclip2.png 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.