How to Setup Wi-Fi (ASH42)

How to Setup Wi-Fi (ASH42)

The Wi-Fi setup method is the preferred setup method for your device. However, if is not an option the camera can also be setup using a direct connection with an Ethernet cable. Please note, the camera can only be setup on either a Wi-Fi only connection or an Ethernet only connection. For more information on how to setup your camera using an Ethernet connection, click here.

For more information on how to setup your camera using Wi-Fi please refer to the information provided below. 

Step 1: Log in and click on “Add Device”.

Step 2: Scan the QR Code on your device or manually enter the serial number for the device by tapping “Manually enter S/N”. The serial number can be found on the serial tag located on the camera.

Step 3: To setup a WiFi connection (recommended) tap “WiFi Setup” to continue.

Note: WiFi setup will only allow your camera to connect via a 2.4GHz Wi-Fi connection. 

Step 4: Ensure the green LED on the front of your camera is blinking, this indicates the camera is ready to be connected.  Tap “Next” to continue.

Step 5: Type in a password you would like to use and confirm it. Please use a combination of letters, numbers, and symbols between 8- 32 characters long when setting up a password. Tap “OK” to continue.

Step 6: Select your Wi-Fi network from the Wi-Fi network list. Enter the password for your home Wi-Fi network. If you would like to save this password to the app, tap on “Save Password”.

Step 7: The LED on the front of camera will turn solid green when connected. If it does not turn solid, tap on “Start Over” to try again. Tap “Next” to continue.

Step 8: Rename your device. A few examples are provided such as, Front Door, Storage Room, Office, etc. Tap “Save” to continue.

Step 9: Set “Time Zone” to your current time zone and set “DST” (Daylight Savings Time) settings if applicable. Tap “Next” to continue.

Step 10: Tap Start Live View to view the live feed.