Reboot Error Codes Explained (1080P HD-CVI)

Whenever the DVR reboots an entry is created in the Log, Information>Log. In the log the entry will list "Reboot with flags" or "Reboot Symbol". It will show a code telling you why the camera rebooted. Please see the list below.

0x00:  DVR has rebooted normally: routine maintenance reboot or a user reboot.

0x01:  Abnormal reboot: power loss,  system crash, or other undefined abnormality.

0x02:  Log stuck.

0x03: Hard drive read-write slow: hard drive read-write speed has dropped significantly, hard drive capacity has seriously decreased.

0x04: Abnormal recording: Over 3 minutes with no stream on the recording channel.

0x05: Bad track: The hard drive has a bad track.

 

Troubleshooting the codes

0x00: Check in Settings>System>Auto Maintain to ensure that the DVR is not set to reboot.

0x01: This one is the hardest one to diagnose. We recommend updating the firmware to the most recent found at www.amcrest.com/firmware, hard resetting the DVR, and ensuring the DVR is receiving consistent power. 

0x02: Clear the log. Go to Information>Log and click Clear.

0x03: Check in Settings>Storage>HDD Manage and look at the Status. If it is not "Normal", it is likely that there is a hard drive error and it needs to be replaced.

0x04: Check all of the camera connections and ensure they are powered correctly.

0x05: Check in Settings>Storage>HDD Manage and look at the Status. If it is not "Normal", it is likely that there is a hard drive error and it needs to be replaced.

 

If you continue to have issues please contact our support team at www.amcrest.com/contacts for further assistance.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.