How to Perform a Factory Reset (IP8M-2696EW)

Prior to performing a physical, hard factory reset, it is recommended to first perform a reset via the web user interface (Web UI) of the camera on a computer. This is useful as well if you do not have direct, physical access to your camera. For more information on how to perform a factory reset in the web UI of your camera, click here.

Note: You will need a Phillips head screwdriver to complete the reset. 

Step 1: Make sure the camera is powered on and using a Phillips head screwdriver, remove the panel on the bottom of the camera

Step 2: On the camera you will notice a microSD card slot and a reset button. The reset button will be labeled "RST". Please note, the reset button is small and a smaller object than your finger may be required to press and hold the reset button. 

To hard factory reset your camera, press and hold this switch down for 30 seconds allowing the camera to reset. 

 

20201005_142035.jpg

 

Once reset, the camera will revert to its original factory settings. The default username and password for the camera will be admin.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.