How To Perform a Factory Reset (IP5M-B1186EW)

How To Perform a Factory Reset (IP5M-B1186EW)

Prior to performing a physical, hard factory reset, it is recommended to first perform a reset via the web user interface (Web UI) of the camera on a computer. This is useful as well if you do not have direct, physical access to your camera. For more information on how to perform a factory reset in the web UI of your camera, click here.

To perform a physical factory reset to this camera, follow the instructions provided below. This instruction set is applicable to the following model cameras: 

IP5M-B1186EW-28MM

Note: You will need a Phillips head screwdriver to complete the reset. 

Step 1: Make sure the camera is powered on and using a Phillips head screwdriver, remove the panel on the bottom of the camera

Step 2: In the panel you will notice a microSD card slot and a reset switch. To hard factory reset your camera, press and hold the switch down for 30 seconds allowing the camera to reset. 

20200929_114214.jpg

Once reset, the camera will revert to its original factory settings. The default username and password for the camera will be admin.

Was this article helpful?
1 out of 1 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.