How To Perform a Factory Reset (IP8M-T2499EW)

How To Perform a Factory Reset (IP8M-T2499EW)

Prior to performing a physical, hard factory reset, it is recommended to first perform a reset via the web user interface (Web UI) of the camera on a computer. This is useful as well if you do not have direct, physical access to your camera. For more information on how to perform a factory reset in the web UI of your camera, click here.

To perform a physical factory reset to this camera, make sure the device is powered on and follow the instructions provided below.

Note: You will need a Phillips head screwdriver and star tool to complete the reset. 

Step 1:  Using the provided star tool, loosen the locking pin of the housing and remove the camera. 

20190423_150838.jpg

20190423_150032.jpg

Step 2: Using a Phillips head screwdriver, remove the 3 screws on the back of the camera to open.

20190423_150131.jpg

Step 3: Open the camera and locate the factory reset switch on the motherboard of the camera. The factory reset switch should be located on the bottom left hand side of the board.

20190423_150402.jpg

Step 4: Press and hold the factory reset switch for 30 seconds allowing the camera to reset. Once reset, the camera will be reverted back to its original factory default settings. The default username and password will be admin.

Was this article helpful?
1 out of 1 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.