How To Perform a Factory Reset (IP2M-842E)

How To Perform a Factory Reset (IP2M-842E)

 

To perform a hard reset on the IP2M-842E, please follow the step by step instructions provided below. 

Note: After performing this procedure, your username and password will be reset back to admin.

Step 1: On the wire harness of the camera, locate the reset wires attached to the unit. The reset wires will be denoted by a green and white wire. 

123.PNG

Step 2: Touch the ends of the wires together and hold for 30 seconds. Separate the wires and give about the camera an additional minute to complete the reset process. 

132.PNG

Congratulations! You have just factory reset your camera. You can now log into your camera using the default username and password which is admin. 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.