How To Perform A Factory Reset

How To Perform a Factory Reset (IP2M-1054E)

To revert your camera back to its original default settings you will need to perform the following procedure. Please follow the process step by step to efficiently complete the process. 

Note: You will need a Phillips head screwdriver to access the factory reset switch of your device.

Step 1: Using a Phillips head screwdriver, remove the security plate located on the bottom of your camera. 

IMG_7478.jpg

Step 2: When the security plate is removed, you will notice the camera's motherboard. On the motherboard you will see the microSD card slot as well as the factory reset switch on the left. 

IMG_7479.jpg

Press and hold the factory reset switch for 20 - 30 seconds and then release. Allow the camera to complete its reset process. Please note, once the camera is successfully reset the login credentials will change to admin for both the username and password. Also, when creating a new password, it is recommended to have a minimum of 8 characters consisting of  a combination of uppercase letters, Lowercase letters, and numbers.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.