How To Perform A Factory Reset (IPM-743E)

How To Perform a Factory Reset On A PoE Bullet Camera

 

The actual reset process on these models requires opening the camera and getting to mother board.  These cameras do not bring a reset switch or wire to perform the process.

Step 1: Unscrew the top of the camera to access the camera's motherboard. 

Step 2: Using a paperclip or something similar, then touching the filaments together for at least 5 seconds and essentially causing a brief short circuit.

f43.JPG

The camera will being the reset process after this has been complete. Please note that once your device resets, you will lose all custom settings set for your camera and your username and password will revert to its original default settings, which is admin

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.