A factory reset of the Indoor IP Camera IP3M-HX2 to its original system state by erasing all of the information stored on the device in an attempt to restore the device's software to its original manufacturer settings.
Note: Prior to performing a physical, hard factory reset, it is recommended to first perform a reset via the web user interface (Web UI) of the camera on a computer. This is useful as well if you do not have direct, physical access to your camera. For more information on how to perform a factory reset in the web UI of your camera, click here.
The IPM-HX2 has an external factory reset button on the backside of the camera labeled 'RST'.
Press and hold the factory reset button for approximately 10 seconds, or until the green light changes to red. Once the light turns red, the process will begin. This will ultimately restore the device to its factory settings and will reset ALL of the camera's settings.
The indicator light located below the camera lens will flash red and green as the camera resets. Wait at least 30 seconds for the camera to complete the reset.
The camera will then be completely reset back to its factory state.
Please sign in to leave a comment.