Password Reset / Factory Reset (IPM-HX1)

A factory reset of the Indoor IP Camera IPM-HX1 to its original system state by erasing all of the information stored on the device in an attempt to restore the device's software to its original manufacturer settings.

The IPM-HX1 has an external factory reset button on the backside of the camera labeled 'RST'.

Press and hold the factory reset button for approximately 10 seconds, or until the green light changes to red. Once the light turns red, the process will begin. This will ultimately restore the device to its factory settings and will reset ALL of the camera's settings.

The indicator light located below the camera lens will flash red and green as the camera resets. Wait at least 30 seconds for the camera to complete the reset. 

The camera will then be completely reset back to its factory state.

 

Was this article helpful?
1 out of 2 found this helpful

Can't find what you're looking for?